THE RESULTS OF THE STUDY ON THE CYCLIC STRENGTH OF THE DEVELOPED CUTTING CERAMICS-Reference-Cited by-同舟云学术

THE RESULTS OF THE STUDY ON THE CYCLIC STRENGTH OF THE DEVELOPED CUTTING CERAMICS

Published:2022-06 Issue:6 Volume: Page:29-33
ISSN:0131-9582
Container-title:Steklo i Keramika
language:
Short-container-title:

Author:

Pronin A. I.,Mylnikov V. V.,Veselov S. V.,Valko D. A.

Abstract

The paper presents the results of a study on the cyclic strength of cutting ceramics: a replaceable polyhedral plate developed at NSTU and VOK-60 cutting ceramics when processing a hardened steel billet made of HVG steel (45 HRC) with two opposite grooves. Turning was performed until the cutting edge of the plates was destroyed. Using the HITACHI S3400N electron microscope, the structure of the destroyed surface layer was investigated and the mechanism of destruction of the cutting edge of tool plates made of cutting ceramics was determined. It has been established that the developed cutting ceramics have a greater resistance to fracture under conditions of intermittent turning of hardened steel compared to the VOK-60 brand. The low operability of the cutting plates made of the developed ceramics under conditions of intermittent turning is mainly caused by the chipping of the cutting edge due to the formation of microcracks at the grain boundaries. A characteristic feature of the mechanism of brittle fracture of cutting ceramics is intergrain tearing and chipping of large Al2O3 grains.

Publisher

Izdatel'skii dom Spektr, LLC

Subject

Ceramics and Composites

Reference9 articles.

1. Иванов В. В., Сорокин Е. В., Павлова Е. В. Сравнение режущих свойств керамики разных марок // СТИН. 2007. № 8. С. 39 – 40.

2. Маслов А. Р. Современная режущая керамика // Главный механик. 2008. № 8. С. 14 – 19.

3. Stephenson D. A., Agapiou J. S. Metal cutting theory and practice. CRC Press, 2005. 864 р.

4. Ямников А. С., Чуприков А. О. Повышение эффективности применения режущей керамики для нарезания резьбы на заготовках из высокопрочных материалов // Цветные металлы. 2017. № 12. С. 85 – 89.

5. Максаров В. В., Халимоненко А. Д. Обеспечение качества при фрезеровании режущей керамикой точных элементов узлов и деталей машин // Современное машиностроение. Наука и образование. 2017. № 6. С. 572 – 582.