The Effect of Fiber Position and Polymerization Condition on the Flexural Properties of Fiber-Reinforced Composite

Abstract

Abstract The aim of this study was to investigate the influence of the position of the fiber rich layer on the flexural properties of fiber-reinforced composite (FRC) construction. In addition, the total residual monomer content of FRC was quantitatively determined to find out the difference of the effectiveness of two types of light-curing units using liquid chromatography (HPLC). Unidirectional continuous E-glass FRC and hybrid particulate filler composite resins were used in the fabrication of test specimens. Four different positions of the FRC layer were used: compression, neutral, tension, and vertical side position. A three-point bending test (ISO 10477) was performed to measure the flexural properties of the specimens. Position of the FRC layer had a significant effect on the flexural strength (p<0.001, ANOVA). Also, the type of light-curing device had an effect on flexural strength (p<0.001). Specimens with FRC positioned on the compression side showed flexural strength of approximately 250 MPa, whereas FRC positioned on the tension side showed strength ranging from 500 to 600 MPa. Mean flexural modulus with FRC placed horizontally ranged between 9-12 GPa; no significant difference was found between these groups. However when fiber reinforcement was positioned vertically, the flexural modulus raised up to 16 GPa. Specimens with 24 vol% glass fibers contained 52% less residual monomer than specimens without glass fibers. The monomer content was lower in specimens polymerized with the curing device with higher polymerization temperature. In order to optimize flexural strength of low fiber volume fraction, the fibers should be placed at the tension side of the specimen. Citation Lassila LVJ, Vallittu PK. The Effect of Fiber Position and Polymerization Condition on the Flexural Properties of Fiber-Reinforced Composite. J Contemp Dent Pract 2004 May;(5)2:014-026.