Affiliation:
1. Bashkir State Agrarian University
2. National Research Mordovia State University
Abstract
Introduction. In this article the study subject is the power supply system of the pre-start heater. The purpose of the study is to evaluate the possibility of using a thermoelectric generator to power the liquid preheater with optimization of the flow section of the thermoelectric generator heat exchanger.
Materials and Methods. It is proposed to use a thermoelectric generator as an additional energy source to reduce electric power consumption by a pre-start heater. In the course of the study, various structures of the flow section of the thermoelectric generator heat exchanger have been modeled. The thermal and hydrodynamic analyses were carried out in the software environment ANSYS Workbench, Solidworks Flow Simulation to develop the most effective design for the flow section of the thermoelectric generator heat exchanger
Results. An experimental installation was assembled and the dependence of the temperature modes of the pre-start heater on the output parameters of the thermoelectric generator was determined.
Discussion and Conclusion. It has been proved the possibility of reducing the power consumption of the vehicle battery during thermal preparation of the internal combustion engine by using a thermoelectric generator adapted to the power supply system of the liquid pre-start heater.
Publisher
National Research Mordovia State University MRSU
Reference19 articles.
1. Negovora A.V., Gusev D.A. Substantiation of Constructive-Regime Parameters of Preheater. Trudy GOSNITI = Works of GOSNITI. 2016; 125:90-96. Available at: https://www.elibrary.ru/item.asp?id=27657634 (accessed 01.03.2021). (In Russ., abstract in Eng.)
2. Mikhaylovskiy V.Ya., Maksimuk N.V. [Modes of Operation of Vehicles at Low Temperatures. Necessity of Using Heaters and Rationality of Using Thermogenerators for Their Operation]. Termoelektrichestvo = Thermoelectricity. 2015; (3):20-30. Available at: http://nbuv.gov.ua/UJRN/ter_2015_3_5 (accessed 01.03.2021). (In Russ., abstract in Eng.)
3. Bell L.E. Cooling, Heating, Generating Power, and Recovering Waste Heat with Thermoelectric Systems. Science. 2008; 321(5895):1457-1461. (In Eng.) DOI: https://doi.org/10.1126/science.1158899
4. Hendricks T.J., Karri N.K., Hogan T.P., Cauchy Ch.J. New Perspectives in Thermoelectric Energy Recovery System Design Optimization. Journal of Electronic Materials. 2013; 42:1725-1736. (In Eng.) DOI: https://doi.org/10.1007/s11664-012-2406-x
5. Maksymuk M.V. Designing of Automotive Pre-Start Heat Sources with Thermoelectric Generator. Vіsnik natsіonalnogo tekhnіchnogo unіversitetu Ukraїni “Kiїvskiy polіtekhnіchniy іnstituˮ. Serіya: priladobuduvannya = Bulletin of the National Technical University of Ukraine “Kyiv Polytechnic Instituteˮ. Series: Instrument Engineering. 2017; (54):53-60. Available at: http://visnykpb.kpi.ua/article/view/119531 (accessed 01.03.2021). (In Ukr., abstract in Eng.)
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献