1. W. Michaeli and G. Potsch, “Injection Molding: An Introduction” (Munchen: Hanser, Fachbuchverlag, 1995).
2. L. Sors and I. Balazs, “Design of Plastic Moulds and Dies” (Elsevier Science and Technology Books, 1989).
3. S. S. Teklehaimanot, “Simulation and Design of A Plastic Injection Mold” (Arcada University of Applied Sciences, Helsinki, Finland, 2012).
4. Review of Factors that Affect Shrinkage of Molded Part in Injection Molding
5. An evolutionary approach for cooling system optimization in plastic injection moulding