Development of a high performance MagLIF target platform using high aspect ratio coated liners and low-mix laser preheat-Reference-Cited by-同舟云学术

Development of a high performance MagLIF target platform using high aspect ratio coated liners and low-mix laser preheat

Published:2024-07-01 Issue:7 Volume:31 Page:
ISSN:1070-664X
Container-title:Physics of Plasmas
language:en
Short-container-title:

Author:

Harvey-Thompson A. J.¹^ORCID,Geissel M. E.¹^ORCID,Lewis W. E.¹^ORCID,Yager-Elorriaga D. A.¹^ORCID,Weis M. R.¹^ORCID,Jennings C. A.¹,Fein J. R.¹^ORCID,Ampleford D. J.¹^ORCID,Gomez M. R.¹^ORCID,Harding E. C.¹^ORCID,Hansen S. B.¹^ORCID,Bliss D. E.¹^ORCID,Chandler G. A.¹^ORCID,Dunham G. S.¹^ORCID,Field E. S.¹^ORCID,Galloway B. R.¹^ORCID,Glinsky M.¹^ORCID,Hahn K. D.²^ORCID,Knapp P. F.³^ORCID,Lamppa D. C.¹^ORCID,Lucero L. M.¹^ORCID,Mangan M. A.¹^ORCID,Paguio R. R.⁴^ORCID,Perea L.¹,Peterson K. J.¹^ORCID,Porter J. L.¹^ORCID,Rambo P. K.¹^ORCID,Robertson G. K.¹,Rochau G. A.¹^ORCID,Ruiz D. E.¹^ORCID,Ruiz C. L.¹^ORCID,Schaeuble M. A.¹^ORCID,Schwarz J.¹^ORCID,Shores J. E.¹,Sinars D. B.¹^ORCID,Slutz S. A.¹^ORCID,Smith G. E.⁴,Smith I. C.¹,Speas C. S.¹,Whittemore K.¹,Yu E. P.¹^ORCID

Affiliation:

1. Sandia National Laboratories 1 , P.O. Box 5800, Albuquerque, New Mexico 87185, USA

2. Lawrence Livermore National Laboratory 3 , Livermore, California 94550, USA

3. Los Alamos National Laboratory 4 , Los Alamos, New Mexico 87545, USA

4. General Atomics 2 , San Diego, California 92121, USA

Abstract

We report on a series of Magnetized Liner Inertial Fusion (MagLIF) experiments conducted on the Z pulsed power facility that utilized high aspect ratio (ratio of outer radius to wall thickness) liners with dielectric coatings and low-mix laser preheat configurations. The liners consisted of an aspect ratio of 10.6 beryllium tube coated with 75 μm of epoxy on the outside that have been shown to maintain a better implosion stability than uncoated beryllium and have demonstrated consistent stagnation performances in previous experiments [Ampleford et al., Phys. Plasmas 31, 022703 (2024)]. Two-dimensional HYDRA simulations were used to design three different “co-injection” laser configurations, whereby a second laser is used to provide an early prepulse before the main pulse, to reduce LEH foil mix while increasing the fuel density and coupled energy. The laser preheat energy for each configuration was constrained using dedicated laser experiments before being applied to the integrated MagLIF experiments on Z. The DD neutron yield for experiments using co-injection preheat configurations is found to increase with the specific preheat energy in line with simulations. The highest neutron yield achieved in this study of 1.1 × 1013 matches the highest reported in a MagLIF experiment to date and is a factor 3.5 times higher than similar experiments using preheat with no phase plate smoothing. We attempt to assess the effects of mix and morphology to explain the improved performance; however, neither factor is found to be conclusive within the uncertainty of the measurements.

Funder

Sandia National Laboratories

Publisher

AIP Publishing

Link

https://pubs.aip.org/aip/pop/article-pdf/doi/10.1063/5.0201770/20079703/072711_1_5.0201770.pdf

Reference42 articles.

1. Pulsed-power-driven cylindrical liner implosions of laser preheated fuel magnetized with an axial field;Phys. Plasmas,2010

2. Experimental demonstration of fusion-relevant conditions in magnetized liner inertial fusion;Phys. Rev. Lett.,2014

3. Scaling magnetized liner inertial fusion on Z and future pulsed-power accelerators;Phys. Plasmas,2016

4. Exploring the parameter space of MagLIF implosions using similarity scaling. II. Current scaling;Phys. Plasmas,2023

5. Pulsed-coil magnet systems for applying uniform 10–30 T fields to centimeter-scale targets on Sandia's Z facility;Rev. Sci. Instrum.,2014