Supersonic cooling film flow evolution on a curved wall under hypersonic flow

Abstract

Curvature plays a crucial role in evolving supersonic cooling film flow-field structures. Flow-field structural images were captured using nanotracer-based planar laser scattering,, and wall pressure values were obtained using experimentally validated numerical simulations. A supersonic cooling film is tangentially injected at the Mach number of Maj = 2.3 into a laminar boundary layer at a mainstream of Ma = 6. The supersonic cooling film inhibits mixing-layer instability on the convex curved wall (CV) and promotes it on the concave curved wall (CC). After increasing the total incoming pressure, the reduction ratio of static pressure (RSP) between the supersonic cooling film and the mainstream flow causes a delay in the position of the mixing-layer instability, smaller-scale vortex structures, and decreased flow velocity of the typical vortex structures on the CC and CV. The wall pressure increases for the CV and decreases for the CC, indicating that the supersonic cooling film suppresses the changes in wall pressure due to curvature. The supersonic cooling film suppresses the decrease in the impulses for bulk dilatation (Ip) due to convex curvature and the increase in Ip due to concave curvature. The growth rate of Ip on the CC increases from −15% to −8% and decreases on the CV from 31% to 12% in the bending impulse (IΦ) range of |IΦ| = 1.337–3.624 for a total inlet pressure of 0.5 MPa. Increasing the RSP could control the Ip values on curved surfaces more effectively. The results of this study can be applied to cooling the infrared optics window on hypersonic vehicles.