Affiliation:
1. South Ural State University
Abstract
Existing methods of metrological self-monitoring of measuring sensors for temperature and pressure of technological industries are considered. The analysis of methods of metrological self-checking of strain gauge pressure sensors is carried out. Method is proposed based on measuring the supply voltage and voltage on the measuring diagonal of the bridge. The temperature of the strain gauge bridge is determined using a semiconductor thermistor installed near the bridge. This allows you to adjust the measured value of the total resistance of the bridge from the temperature of the bridge. With aging and exposure to external conditions, a change in the overall resistance of the bridge can be used to judge the error of the sensor. An experimental sample of the sensor was made. The failure of the strain gage bridge is simulated by parallel connection of an additional resistor to one of the shoulders of the bridge. Experimental studies have shown that modern technical means make it possible to assess the effect of changes in the total bridge resistance on the sensor error.
Publisher
FSUE VNIIMS All-Russian Research Institute of Metrological Service
Subject
General Earth and Planetary Sciences,Water Science and Technology,Geography, Planning and Development
Reference16 articles.
1. Yang, J. C., Clarke D. W., IEEE Transactions on Control Systems Technology, 1997, vol. 5, no. 2, pp. 239–253. DOI:10.1109/87.556028
2. Barberree D. Temperature: Its Measurement and Control in Science and Industry, USA, 2003. New York, vol. 7, pp. 1097–2001.
3. Eryurek E. S., Esboldt G., Rome, US Patent no. 6,434,504 B1 (13 Aug. 2002).
4. Declan J., Aurik A., Claire E., Measurement Science and Technology, 2018, vol. 29, no. 10. DOI: 10.1088/1361–6501/aad8a8.
5. Mokdad S., Failleau G., Deuzé T., International Journal of Thermophysics, 2015, vol. 36, no. 8, pp. 1895–1908. DOI:10.1007/s10765–015–1891–6