Stiffness of reinforced concrete structures under bending considering shear and axial forces (part 2)-Reference-Cited by-同舟云学术

Stiffness of reinforced concrete structures under bending considering shear and axial forces (part 2)

Published:2024-05-06 Issue:2 Volume: Page:16-27
ISSN:2073-7416
Container-title:Building and Reconstruction
language:
Short-container-title:jour

Author:

Kolchunov Vl. I.¹,Krylov S. B.²,Fedorov S. S.³

Affiliation:

1. National Research Moscow State University of Civil Engineering; Scientific Research Institute of Construction Physics of the Russian Academy of Architecture and Construction Sciences

2. Gvozdev Research Institute of Reinforced Concrete, JSC SIC Construction

3. National Research Moscow State University of Civil Engineering

Abstract

The paper presents a physical and computational model for determining the parameters of limit states of reinforced concrete structures under complex stressed state - bending with axial and shear forces. Based on the adopted scheme of cross-section discretization and A.R. Rzhanitsyn's theorem of duality between force and deformation parameters, the forward and backward transfer for determining the coefficients of the stiffness matrix of reinforced concrete rod structures with inclined and normal cracks have been constructed. Stiffness of structures in the zone of inclined cracks is determined using the model of composite strips which separate the zone with inclined cracks. The hypothesis about the character of deformation distribution in a complex-stressed reinforced concrete element with inclined cracks is accepted.For this model the conditional shear modulus is obtained, which allows to determine the average relative linear and angular strains of concrete and reinforcement at the point adjacent to the shear joint between inclined cracks. Based on this model and using the experimentally obtained value of the relative shear in the inclined crack, the dowel forces in the reinforcing bar intersected by the inclined crack were determined. The application of the obtained analytical relationships in the practice of designing reinforced concrete structures allows not only to clarify significantly the definition of displacements and width of opening of inclined and normal cracks, but also to maximize the convergence of the design and physical model based on experimental data.

Publisher

Orel State University

Reference26 articles.

1. Arzamastsev S.A., Rodevich V.V. To the calculation of reinforced concrete elements for bending with torsion. Proceedings of higher educational institutions. Building. 2015. vol. 681. no. 9, Pp. 99-109.

2. IlkerKalkan, SaruhanKartal. Torsional Rigidities of Reinforced Concrete Beams Subjected to Elastic Lateral Torsional Buckling. International Journal of Civil and Environmental Engineering. 2017. Vol. 11. No.7. Pp. 969–972.

3. G. Klein, G. Lucier, S. Rizkalla, P. Zia and H. Gleich. Torsion simplified: a failure plane model for desigh of spandrel beams. ACI Concrete International Journal. 2012. February. Pp.1-19

4. Lin W. Experimental investigation on composite beams under combined negative bending and torsional moments. Advances in Structural Engineering. 2021. 24(6). Pp. 1456–1465. DOI: 10.1177/1369433220981660.

5. Zalesov A.S., Mukhamediev T.A., Chistyakov E.A. Calculation of crack resistance of reinforced concrete structures according to new normative documents. Concrete and Reinforced Concrete. 2002. No. 5. Pp. 15-18.