Obtaining and Characterizing 3D Printable Polymer Based Composites with BaTiO3 Filler
-
Published:2021-04-05
Issue:1
Volume:58
Page:11-18
-
ISSN:0025-5289
-
Container-title:Materiale Plastice
-
language:en
-
Short-container-title:Mater. Plast.
Author:
Caramitu Alina Ruxandra,Dascalu Radu,Ion Ioana,Tsakiris Violeta,Stancu Nicolae,Aradoaei Mihaela,Ciobanu Romeo Cristian,Bors Adriana Mariana,Lingvay Iosif
Abstract
By the extrusion and injection technique, polymer-based composite samples (polypropylene and thermoplastic polyurethane) were obtained with BaTiO3 filler in concentrations between 0 and 35 %. Following the preliminary characterizations performed by coupled thermal analysis techniques, it was found that the composite samples obtained have thermal stability up to a temperature of about 250 oC and can be processed by extrusion at temperatures between 180 and 240oC. Above this temperature, a series of degradation processes take place by successive thermooxidation with the formation of volatile products.The electrical characterization of the composite samples was performed by the dielectric spectroscopy technique, which showed that the A tga dielectric losses increase as the BaTiO3 content of the composite increases. The maximum increase being recorded at 50 Hz (the slope A tga /% BaTiO3 about 0.003 /% BaTiO3). It was also found, that the electrical conductivity (o) of the composite increases with the increase of content in BaTiO3 so that o at 100 kHz for the composite with 35 % BaTiO3 is about 50 times higher than for the reference sample M 0 (without filler).
Publisher
Revista de Chimie SRL
Subject
Materials Chemistry,Polymers and Plastics,Mechanics of Materials,General Chemistry
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献