Ironing process in conditions of constant and variable lateral force-Reference-Cited by-同舟云学术

Ironing process in conditions of constant and variable lateral force

Published:2020-12-15 Issue:2 Volume:46 Page:1-5
ISSN:2620-147X
Container-title:Advanced Technologies & Materials
language:en
Short-container-title:Adv.Tech&Mat.

Author:

Djačić Slaviša¹^ORCID,Aleksandrović Srbislav²^ORCID,Arsić Dušan²^ORCID,Delić Marko²^ORCID,Lazić Vukić²^ORCID

Affiliation:

1. Coal mine, Pljevlja, Montenegro

2. Faculty of Engineering, University of Kragujevac, Sestre Janjica 6, Kragujevac, Serbia

Abstract

Comparison of application of constant and variable lateral force in strip ironing process with double side thinning are presented in the paper. Given are the experimental results for single and multiphase ironing process with constant lateral force during the course of particular process. Material used was mild steel DC04. Stripes were 20 mm wide and 2.5 mm thick.Constant lateral force intensities were 5, 10 and 15 kN. Lubrication was with appropriate mineral oil and grease.In other side given is analysis of idea of possibility to apply variable lateral force during the strip ironing process and consequences of this action. Expected is control of strip thickness variation with difficulties because of contact and other appearances influence.

Funder

Ministarstvo Prosvete, Nauke i Tehnološkog Razvoja

Publisher

Faculty of Technical Sciences

Subject

General Medicine

Reference16 articles.

1. Schlosser, D. (1975). Beeinflussung der Reibung beim Streifenziehen von austenitischem Blech: verschiedene Schmierstoffe und Werkzeuge aus gesinterten Hartstoffen. Bander Bleche Rohre, No. 7/8, p. 302-306. (In German).

2. Deneuville, P., Lecot, R. (1994).The study of friction in ironing process by physical and numerical modelling. Journal of Materials Processing Technology, Vol. 45, No. 1-4, p. 625–630. DOI: https://doi.org/10.1016/0924-0136(94)90409-X

3. Andreasen, J.L., Bay, N., Andersen, M., Christensen, E., Bjerrum, N. (1997). Screening the performance of lubricants for the ironing of stainless steel with a strip reduction test, Wear,Vol. 207, No. 1-2, pp. 1-5.

4. Sulaiman, H., Christiansen, P., Bay, N. (2017). Influence of tool texture on friction and lubrication in strip reduction, Procedia Engineering, No. 207, p. 2263–2268. DOI: https://doi.org/10.1016/j.proeng.2017.10.992

5. Ustunyagiz, E., Nielsen, C., Christiansen, P., Martins, P., Bay, N. (2017). Continuous Strip Reduction Test Simulating Tribological Conditions in Ironing, Procedia Engineering, No. 207, p. 2286–2291. DOI: https://doi.org/10.1016/j.proeng.2017.10.996