Effect of fuel injection pressure on the performances of a CI engine using water-emulsified diesel (WED) as a fuel

Abstract

Abstract Background The choice of energy sources is essential for sustainable development to combat different environmental issues caused by the consumption of fossil fuels. Though diesel engines are considered more efficient and reliable than other internal combustion engines, they emit different harmful pollutants which are detrimental to human health and the environment. Researchers are trying to find suitable alternative fuels for diesel engines with lower pollutant emissions and without much compromise in the efficiency of the engine. In this regard, water-emulsified diesel (WED) may be considered to be one of the most suitable alternative fuels. It is expected that the entire world will use electric vehicles in the long term. However, the complete replacement of IC engines in the near future is not feasible. In fact, different European countries have targeted to ban the use of diesel engine cars before the middle of the twenty-first century. Prior to that date, hybrid vehicles will be more popular and diesel engines will continue to play an important role. Hence, research involving improvements in diesel-operated IC engines is still relevant. Methods An experimental investigation was carried out using WED containing 10% water by volume as a fuel in a diesel engine at four different fuel injection pressures. The WED was prepared using an ultrasonicator. Results With the increase of injection pressure, peak net heat release rate and in-cylinder pressure are found to have increased. Brake thermal efficiency is also found to have improved at higher injection pressure. The maximum efficiency was recorded when a WED at 210 bar of injection pressure is used, and it is about 3.3% higher than the maximum efficiency achieved when using normal diesel at the same pressure of fuel injection. At a higher load, neat brake-specific fuel consumption is found to be less compared to neat diesel, when only the amount of diesel contained in the emulsion as a fuel is considered. Maximum reduction in both NOx and smoke emission by using WED is recorded at 210 bar, and the average reductions are determined to be 32.6% and 51.9%, respectively. Conclusions WED can be used as an alternative fuel for existing diesel engines without any retrofitting and with significant reduction in the emissions of pollutants compared to normal diesel fuel. It can also be concluded that at higher injection pressure, the combustion, performance and emission characteristics of compression ignition engines are improved when using emulsified diesel.