Evaluating an enhanced thermal response test (ETRT) with high groundwater flow

Abstract

AbstractEnhanced thermal response tests (ETRT) enable the evaluation of depth-specific effective thermal conductivities. Groundwater flow can significantly influence the interpretation of ETRT results. Hence, this study aims to critically evaluate an ETRT with high groundwater flow (> 0.2 m d−1). Different approaches in determining the specific heat load of an ETRT are compared. The results show that assuming constant electrical resistance of the heating cable with time can account for an inaccuracy of 12% in the determination of effective thermal conductivities. Adjusting the specific heat loads along the borehole heat exchanger (BHE) depth, the specific heat loads vary within 3%. Applying the infinite line source model (ILS) and Péclet number analysis, a depth–average hydraulic conductivity is estimated to be 3.1 × 10–3 m s−1, thereby, confirming the results of a pumping test of a previous study. For high Darcy velocities (> 0.6 m d−1), the uncertainty is higher due to experimental limitations in ensuring a sufficient temperature increase for the evaluation (ΔT > 0.6 K). In these depths, the convergence criterion of Δλeff/λeff < 0.05/20 h for the ILS sequential forward evaluation cannot be achieved. Thus, it can be concluded that time-averaging of the heat load by monitoring voltage and current during ETRT is essential. Therefore, the specific heat load adjustment along the heating cable is recommended. To improve the estimation of depth-specific effective conductivities with high groundwater flow and to reduce the sensitivity towards temperature fluctuations (ΔT ~ 0.1 K), measures for applying higher specific heat loads during the ETRT are essential, such as actions against overheating of the cable outside the BHE.