Comparison of two techniques for measuring two-dimensional strain in rat left ventricles

Abstract

Measurements of regional deformation in the left ventricle are needed to understand the structural basis of ventricular function. Two techniques were employed to measure two-dimensional strain in the intact, beating rat heart. Rats were anesthetized and ventilated, and the chest of each rat was opened. Homogeneous two-dimensional strains were measured during the cardiac cycle relative to end diastole with either a triangle of miniature (0.3-0.5 mm) piezoelectric crystals implanted at midwall or with three epicardial surface markers imaged with a 60-Hz video system. Average heart rate was 303 +/- 37 beats/min, end-diastolic pressure was 2 +/- 2 mmHg, and peak-systolic pressure was 106 +/- 31 mmHg in all of the hearts. In general, strains during the cardiac cycle showed similar trends to those previously reported in the dog. The magnitudes of peak systolic cardiac strains on the epicardium and at midwall were -0.076 +/- 0.055, -0.068 +/- 0.014 (circumferential), -0.102 +/- 0.040, -0.082 +/- 0.039 (longitudinal), and 0.065 +/- 0.016, 0.064 +/- 0.043 (in-plane shear). There were mechanical side effects due to the crystal implantation that may limit the usefulness of this technique in its present form in the contracting rat heart. The epicardial surface technique does not have these side effects and will allow measurements of regional systolic cardiac function in rats with pathological interventions or genetic modifications that may alter regional ventricular function.