Affiliation:
1. Gdansk University of Technology , Faculty of Ocean Engineering and Ship Technology , Poland
2. Centre for Marine Technology and Ocean Engineering (CENTEC), Instituto Superior Técnico , Universidade de Lisboa , Portugal
Abstract
Abstract
The objective of this study is to analyse the behaviour of compressed stiffened plates of different slenderness using experimental and numerical methods. The presented results are part of a long-term project to investigate the ultimate strength of geometrically imperfect structures subjected to different degradation phenomena, including corrosion degradation and locked cracks. Several specimens were subjected to a uniaxial compressive force, and the most important quantities related to the structural behaviour were captured and analysed. A finite element model, accounting for material and geometrical nonlinearities and initial geometrical imperfections, was developed using the commercial software ANSYS. The residual welding-induced stresses were measured in the middle cross-section for two specimens. The initial imperfection was identified by employing a close-range photogrammetry approach. It was concluded that the numerical analyses, based on the finite element model, predict the ultimate strength of stiffened plates accurately, although some deviations were also observed. The detailed analysis with the indication of possible uncertainty is presented, and several conclusions are derived.
Subject
Mechanical Engineering,Ocean Engineering
Reference30 articles.
1. 1. M. Taczala, “Approximate method for evaluation of stress-strain relationship for stiffened panel subject to tension, compression and shear employing the finite element approach,” Proc. MARSTRUCT 2009, 2nd Int. Conf. Mar. Struct. Des. Mar. Struct., 2009. pp. 155–61.
2. 2. J. Czujko, A. Bayatfar, M. Smith, M. Xu, D. Wang, M. Lützen et al., “Committee III.1: Ultimate Strength,” in: M. Kaminski, P. Rigo, Eds. Proc. 20th Int. Sh. Offshore Struct. Congr. (ISSC 2018), vol. 1, IOP Press; 2018. pp. 335–439.
3. 3. D.W. Lang, W.G. Warren, “Structural strength investigations on the destroyer Albuera,” Trans. Inst. Nav. Arch., vol. 94, pp. 243–86, 1952.
4. 4. Y. Wang, S. Xu, A. Li, “Flexural performance evaluation of corroded steel beams based on 3D corrosion morphology,” Struct. Infrastruct. Eng., vol. 16, pp. 1–16, 2020.
5. 5. D. Faulkner, “A review of effective plating for use in the analysis of stiffened plating in bending and compression,” J. Sh. Res., vol. 19, pp. 1–17, 1975.
Cited by
12 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献