Affiliation:
1. Institute of Radio Technique and Telecommunication Technologies, Saint Petersburg State University of Aerospace Instrumentation
Abstract
Introduction. Constant false alarm rate (CFAR) detectors have found application in synthetic aperture radar (SAR) systems. The operating principle of a classic cell averaging detector (CA-CFAR detector) is based on comparing the decision statistics in the test resolution element with an adaptive threshold, which is calculated from signals in the reference cells. The decision statistic is an estimate of the signal power. Therefore, target signal detection is based on the brightness contrast of the test and reference resolution cells. Such a detector is optimal provided that the noise background is homogeneous. In cases where the background homogeneity is violated, the quality of detection deteriorates. There are several known methods for improving the quality of detection (GO-CFAR, SO-CFAR, OS-CFAR, etc.). However, the precise principle of detection by brightness contrast in such CFAR detectors remains unchanged.Aim. To synthesize a CFAR detector that uses not only the brightness contrast between the test and reference resolution cells, but also the spectral differences of the signals.Materials and methods. The proposed CFAR detector uses estimates of the algebraic moments of the power spectral density of signals in range cells, based on which three decision statistics are calculated containing information about the power, the position of the energy center, and the width of the signal spectrum. The decision about the presence of a target in the test cell is carried out according to the 2/3 rule (2 threshold overshoots out of 3 comparisons).Results. A comparison of the proposed detector with the SO-CFAR detector, performed by computer simulation, showed that, under a signal-to-clutter ratio of -6 dB and a false alarm probability of 10-4, the detection probability of the proposed detector was 0.933 versus 0.708 for the SO-CFAR detector.Conclusion. The article proposes a three-parameter CFAR detector for a synthetic aperture radar system, in which the decision on the presence of a target in the test cell is made via estimation of the first three algebraic moments of the signal spectrum. The synthesized detection algorithm can also be used when detecting moving targets in SAR.
Publisher
St. Petersburg Electrotechnical University LETI
Reference27 articles.
1. Gandhi P. P., Kassam S. A. Analysis of CFAR Processors in Non-Homogeneous Background. IEEE Transactions on Aerospace and Electronic Systems. 1988, vol. 24, no. 4, pp. 427-445. doi: 10.1109/7.7185
2. Finn H. M., Johnson R. S. Adaptive Detection Mode with Threshold Control as a Function of Spatially Sampled Clutter Level Estimates. RCA Review. 1968, vol. 29, pp. 414-468.
3. Moore J. D., Lawrence N. B. Comparison of Two CFAR Methods Used with Square Law Detection of Swerling I Targets. Proc. of the IEEE Intern. Radar Conf., Arlington, VA, April 1980, pp. 403-409.
4. Weiss M. Analysis of Some Modified Cell-Averaging CFAR Processors in Multiple-Target Situations. Transactions on Aerospace and Electronic Systems. 1982, vol. 18, no. 1, pp. 102-113. doi: 10.1109/taes.1982.309210
5. Hansen V. G. Constant False Alarm Rate Processing in Search Radars. Proc. of the IEEE Intern. Radar Conf., London, UK, 1973, pp. 325-332.