Forecasting the Use of Argon Mix (Ar-Co2) in the FCAW Welding Process Using the Moving Average and Single Exponential Smoothing Methods-Reference-Cited by-同舟云学术

Forecasting the Use of Argon Mix (Ar-Co2) in the FCAW Welding Process Using the Moving Average and Single Exponential Smoothing Methods

Published:2022-08-26 Issue:2 Volume:2 Page:
ISSN:2807-2243
Container-title:Procedia of Engineering and Life Science
language:
Short-container-title:PELS

Author:

Wildan ,Nurrohkayati Anis Siti

Abstract

Welding has a very important role in metal engineering and repair, therefore technological developments in the increasingly advanced construction sector cannot be separated from welding. FCAW (Flux Cored Arc Welding) is a welding process that is often used in the industrial world where the welding process uses an electric arc as a heat source to melt metal, using gas as a shield and electrodes as a filler. This study analyses the use of shielding gas by observing the welding process and then taking the welding result data which is then calculated using the moving average forecasting method and single exponential smoothing. The data from the analysis obtained an average amperage of 257, argon flow rate of 34.45 L/min with a time of 25.31 seconds using argon as much as 265.90 psi or in one argon mix tube with the content of 2.175 psi it took 3 hours 45 minutes total welding time

Publisher

Universitas Muhammadiyah Sidoarjo

Reference10 articles.

1. I. Utama, P. I. S Dan E. Pranata, “Pengaruh Variasi Arus Las Pada Pengelasan Fcaw Dari Material Baja Kapal Astm Ss 400,” Semitan Ii, 2020.

2. M. Arsyad, A. H. Razak Dan H. , “Penerapan K3 Dalam Proses Pengelasan,” Prosiding Seminar Nasional Penelitian & Pengabdian Kepada Masyarakat, 2019.

3. A. Ardiansyah Dan Y. , “Studi Hasil Proses Pengelasan Fcaw (Flux Cored Arc Welding) Pada Material St 41 Dengan Variasi Media Pendingin Terhadap Kekuatan Tarik Dan Struktur Mikro,” Jtm, 2019.

4. M. A. P. Famoesa, P. I. S Dan E. Pranata, “Pengaruh Variasi Sudut Kampuh V Pada Sambungan Las Fcaw Dari Material Baja Ss 400,” Semitan Ii, 2020.

5. I. Utama, P. I. S Dan E. Pranata, “Pengaruh Variasi Arus Las Pada Pengelasan Fcaw Dari Material Baja Kapal Astm Ss 400,” Semitan Ii, 2020.