Abstract
fourth generation cellular network based on Long Term Evaluation (LTE) air interface. LTE is specifically designed for packet data communications, where the emphasis of the technologies high spectral efficiency, high peak data rates, low latency, and frequency flexibility. In this paper a LTE physical layer design and implemented using MATLAB codes and Simulink, where MATLAB codes generate the 64 QAM transmitting signal and simulating LTE frames while Simulink model perform the physical layer which including the band limiting, free space path loss adding, channel, RF receiver, demodulation, 10-bit ADC, DC offset cancellation, saving data to preform EVM measurements, and viewing the spectrum signal after each block, finally QAM with multi –order tested under AWGN.
Publisher
Institute of Advanced Engineering and Science
Subject
Electrical and Electronic Engineering,Control and Optimization,Computer Networks and Communications,Hardware and Architecture,Information Systems,Signal Processing
Cited by
8 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献
1. LTE Transceiver Modeling in MATLAB Simulink;2023 Third International Conference on Advances in Electrical, Computing, Communication and Sustainable Technologies (ICAECT);2023-01-05
2. 5G and 6G WiFi Transceiver Comparison in Multi Modulation Schemes Performance with MATLAB Simulink;2023 Third International Conference on Advances in Electrical, Computing, Communication and Sustainable Technologies (ICAECT);2023-01-05
3. High bit rate modulation approach used by new generation mobile technology;AIP Conference Proceedings;2023
4. Wi-Fi 6 performance in multi modulation scheme with MATLAB Simulink;AIP Conference Proceedings;2023
5. Performance evaluation of a deployed radio-LTE network using turbo equalization technique;5TH INTERNATIONAL CONFERENCE ON ELECTRICAL, ELECTRONIC, COMMUNICATION AND CONTROL ENGINEERING (ICEECC 2021);2023