Fast cavity surface temperature evolution in injection molding: control of cooling stage and final morphology analysis-Reference-Cited by-同舟云学术

Fast cavity surface temperature evolution in injection molding: control of cooling stage and final morphology analysis

Published:2016 Issue:101 Volume:6 Page:99274-99281
ISSN:2046-2069
Container-title:RSC Advances
language:en
Short-container-title:RSC Adv.

Author:

Liparoti Sara¹²³⁴^ORCID,Sorrentino Andrea⁵⁶⁴^ORCID,Titomanlio Giuseppe¹²³⁴

Affiliation:

1. Department of Industrial Engineering

2. University of Salerno

3. 84084 Fisciano

4. Italy

5. Institute for Polymers, Composites and Biomaterials (IPCB-CNR)

6. 80055 Portici

Abstract

New isotropic morphologies are obtained by controlling pressure and temperature evolution.

Publisher

Royal Society of Chemistry (RSC)

Subject

General Chemical Engineering,General Chemistry

Link

http://pubs.rsc.org/en/content/articlepdf/2016/RA/C6RA22968A

Reference35 articles.

1. C. T. Leondes , Mems/Nems: (1) Handbook Techniques and Applications Design Methods, (2) Fabrication Techniques, (3) Manufacturing Methods, (4) Sensors and Actuators, (5) Medical Applications and MOEMS, Springer Science & Business Media, 2007

2. Microinjection molding of thermoplastic polymers: a review

3. J. Greener and R.Wimberger-Friedl, Precision injection molding, Carl Hanser, Munich, 2006

4. Injection molding of nanopatterned surfaces in the sub-micrometer range with induction heating aid

5. Induction heating with the ring effect for injection molding plates

Cited by 26 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. The Influence of Injection Parameters on the Thermomechanical Properties of a Polyamide Product;Lecture Notes in Mechanical Engineering;2024

2. Fabrication of the low‐residual‐stress optical microstructure by using the simulation and practice strategies, in‐mold induction heating system, and injection compression molding technology;Polymer Engineering & Science;2023-06-02

3. One-pot exfoliation and surface functionalization of MoS2: A potential nanofiller to overcome the brittleness of polystyrene (PS);Polymer;2021-10

4. A method to obtain the quantitative orientation of semicrystalline structures in polymers by atomic force microscopy;Express Polymer Letters;2021

5. A quick response and tribologically durable graphene heater for rapid heat cycle molding and its applications in injection molding;Applied Thermal Engineering;2020-02