Recent advances in additive manufacturing of engineering thermoplastics: challenges and opportunities-Reference-Cited by-同舟云学术

Recent advances in additive manufacturing of engineering thermoplastics: challenges and opportunities

Published:2020 Issue:59 Volume:10 Page:36058-36089
ISSN:2046-2069
Container-title:RSC Advances
language:en
Short-container-title:RSC Adv.

Author:

Picard Maisyn¹²³⁴⁵^ORCID,Mohanty Amar K.¹²³⁴⁵^ORCID,Misra Manjusri¹²³⁴⁵^ORCID

Affiliation:

1. School of Engineering

2. University of Guelph

3. Guelph

4. Canada

5. Bioproducts Discovery and Development Centre

Abstract

There are many limitations within three-dimensional (3D) printing that hinder its adaptation into industries such as biomedical, cosmetic, processing, automotive, aerospace, and electronics.

Funder

Ontario Ministry of Agriculture, Food and Rural Affairs

Natural Sciences and Engineering Research Council of Canada

Ontario Ministry of Economic Development, Job Creation and Trade

FedDev Ontario

Canada Foundation for Innovation

University of Guelph

Publisher

Royal Society of Chemistry (RSC)

Subject

General Chemical Engineering,General Chemistry

Link

http://pubs.rsc.org/en/content/articlepdf/2020/RA/D0RA04857G

Reference224 articles.

1. 3D printing: the dawn of a new era in manufacturing?

2. Composites from renewable and sustainable resources: Challenges and innovations

3. Additive manufacturing (3D printing): A review of materials, methods, applications and challenges

4. Rapid design and manufacture tools in architecture

5. Improving the Impact Strength and Heat Resistance of 3D Printed Models: Structure, Property, and Processing Correlationships during Fused Deposition Modeling (FDM) of Poly(Lactic Acid)

Cited by 60 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Refined kinetic model for the simulation of polycarbonate synthesis via continuous melt transesterification;Chemical Engineering Science;2024-12

2. Analysis of the influence of printing parameters on the compression resistance of PLA in the FDM process;Rapid Prototyping Journal;2024-09-16

3. In situ X-ray diffraction and thermal simulation of material extrusion additive manufacturing of polymer;Materials & Design;2024-09

4. RELAXATION BEHAVIOR OF 3D PRINTED NBR-BASED RUBBER O-RINGS AS THE INNER PART OF ROD SEALS;Rubber Chemistry and Technology;2024-09-01

5. Effect of sample dimensions on the stiffness of PA12 Lattice materials fabricated using Powder Bed Fusion;Additive Manufacturing;2024-09