Modular 3D-printed fluorometer/photometer for determination of iron(<scp>ii</scp>), caffeine, and ciprofloxacin in pharmaceutical samples-Reference-Cited by-同舟云学术

Modular 3D-printed fluorometer/photometer for determination of iron(ii), caffeine, and ciprofloxacin in pharmaceutical samples

Published:2023 Issue:18 Volume:13 Page:12050-12058
ISSN:2046-2069
Container-title:RSC Advances
language:en
Short-container-title:RSC Adv.

Author:

Lamarca Rafaela Silva¹^ORCID,Silva João Pedro¹^ORCID,Varoni dos Santos João Paulo¹^ORCID,Ayala-Durán Saidy Cristina¹^ORCID,Lima Gomes Paulo Clairmont Feitosa de¹^ORCID

Affiliation:

1. Department of Analytical Chemistry, Physical Chemistry and Inorganic Chemistry, National Institute for Alternative Technologies of Detection, Toxicological Evaluation and Removal of Micropollutants and Radioactives (INCT-DATREM), Institute of Chemistry, São Paulo State University (UNESP), Araraquara, São Paulo, 14800-060, Brazil

Abstract

A low-cost modular 3D-printed fluorometer/photometer was built and applied to determine iron(ii), caffeine and ciprofloxacin in pharmaceutical samples.

Funder

Conselho Nacional de Desenvolvimento Científico e Tecnológico

Fundação de Amparo à Pesquisa do Estado de São Paulo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior

Publisher

Royal Society of Chemistry (RSC)

Subject

General Chemical Engineering,General Chemistry

Link

http://pubs.rsc.org/en/content/articlepdf/2023/RA/D3RA01281F

Reference29 articles.

1. Review of 3D-Printed functionalized devices for chemical and biochemical analysis

2. Opportunities for 3D printed millifluidic platforms incorporating on-line sample handling and separation

3. (Bio)Analytical chemistry enabled by 3D printing: Sensors and biosensors

4. Additive-manufactured (3D-printed) electrochemical sensors: A critical review

5. Confinement of Monolithic Stationary Phases in Targeted Regions of 3D-Printed Titanium Devices Using Thermal Polymerization