Optimization of spring parameters by using the Bees algorithm for the foldable wing mechanism

Abstract

AbstractIn this study, the design of the torsion and compression springs of the foldable wing mechanism used in the missile is considered an optimization problem. After the missile leaves the tube, the wings waiting in a closed state must be opened and fixed within a specific time. The study it is aimed to maximize the energy stored by the springs so that the wing can be opened in a minimum time. In this context, the energy equation in both publications is defined as the objective function in the optimization process. Wire diameter, coiling diameter, coiling number, and deflection parameters required for spring design were determined as optimization variables. There are geometrical constraints for the variables due to the dimensions of the mechanism and there are also safety factor constraints due to the loads to which the springs are exposed. The Bees Algorithm (BA) was used to solve this optimization problem and perform the spring design. The energy values obtained with BA were better than the values obtained with the Design of Experiment (DOE) study before. The springs and mechanism designed with the parameters obtained from the optimization were first analyzed in the ADAMS program. Afterward, experimental tests carried out by integrating the produced springs into the actual mechanism. As a result of the tests, it was observed that the wing opened at approximately 90 ms. This value is well below the project target of 200 ms. In addition, there is only a 16 ms difference between the analysis and the experimental results.