Feasibility analysis of novel Maglev EDM by comparing with conventional micro EDM

Abstract

AbstractEDM is the most popular unconventional machining process. The present technology of EDM consists of a pulsed or capacitive type power supply in which the pulsed type power supply is more popular and effective. The following essential component of an EDM is its servo mechanism, which controls the gap between the electrodes and maintains the gap voltage. A low machining speed, complex power supply, and servo mechanism increase the cost of machining and the maintenance cost of an EDM machine. To resolve the above issues from the EDM, a novel servo mechanism has been developed, which is simple in design and low in cost and has the capacity to use direct current as a power source. The current work elaborates a brief description of the novel servo mechanism and its feasibility analysis. Pure DC power is employed with the conjunction of Maglev lucidity to refine the shortcomings of conventional micro EDM. The novel technology addresses the prime concerns of conventional micro EDMs and deficiencies such as the delayed response of mechanical actuators and a servo mechanism. The novel technology uses the logical arrangement of permanent magnets and electromagnets to address inadequacies such as short circuiting and arcing. The work outlook is to establish the viability of the novel Maglev EDM by a comparison with a similar range of parameters. The results on the novel technology showed an improved material removal rate (MRR), which was in the range of 76.6 μgm/min, whereas the specific energy and surface roughness were 33.4 Joule/microgram and 4.3 μm, respectively, while machining commercially pure titanium.