Delamination/Rupture of Polycrystalline Diamond Film: Defining Role of Shear Anisotropy-Reference-Cited by-同舟云学术

Delamination/Rupture of Polycrystalline Diamond Film: Defining Role of Shear Anisotropy

Published:2017-03-14 Issue:4 Volume:17 Page:1514-1523
ISSN:1528-7483
Container-title:Crystal Growth & Design
language:en
Short-container-title:Crystal Growth & Design

Author:

Jain L.¹,Bajpai Reeti¹,Basu Ritwik¹,Misra Devi Shanker¹,Samajdar Indradev¹

Affiliation:

1. Department of Physics and ‡Department of Metallurgical Engineering and Materials Science, Indian Institute of Technology Bombay, Mumbai 400 076, India

Funder

Department of Science and Technology, Ministry of Science and Technology

Publisher

American Chemical Society (ACS)

Subject

Condensed Matter Physics,General Materials Science,General Chemistry

Link

https://pubs.acs.org/doi/pdf/10.1021/acs.cgd.6b01328

Reference48 articles.

1. Adhesion and residual stresses determination of thermally sprayed molybdenum on steel

2. Adhesion and stress of magnesium oxide thin films: Effect of thickness, oxidation temperature and duration

3. Thermal stresses in diamond coatings and their influence on coating wear and failure

4. Tribological behaviour and internal stress of diamond coating deposited with a stationary d.c. plasma jet

Cited by 8 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Growth selection induced residual stresses and fracture behavior of as‐deposited thermal barrier coatings;Journal of the American Ceramic Society;2024-08-18

2. X-ray Diffraction for the Determination of Residual Stress of Crystalline Material: An Overview;Transactions of the Indian Institute of Metals;2022-03-07

3. The origin of graphite morphology in cast iron;Acta Materialia;2022-03

4. Observation of enhanced magnetic anisotropy in PLD YIG thin film on GGG (1 1 1) substrate;Journal of Magnetism and Magnetic Materials;2019-08

5. Observed edge radius behavior during MD nanomachining of silicon at a high uncut chip thickness;The International Journal of Advanced Manufacturing Technology;2018-11-24