Analysis of the Hydrodynamics of Swirling Flows in Direct-Flow Cyclones-Reference-Cited by-同舟云学术

Analysis of the Hydrodynamics of Swirling Flows in Direct-Flow Cyclones

Published:2023-12-15 Issue:1 Volume: Page:112-120
ISSN:0044-4618
Container-title:Журнал прикладной химии
language:
Short-container-title:Žurnal prikladnoj himii

Author:

Toptalov V. S.¹,Chesnokov Yu. G.¹,Flisyuk O. M.¹,Martsulevich N. A.¹,Likhachev I. G.¹

Affiliation:

1. St. Petersburg State Institute of Technology (Technical University), 190013, St. Petersburg, Russia

Abstract

A mathematical model is presented that describes the movement of gas in a direct-flow cyclone. The equations of motion of the gas phase were solved and profiles for the tangential and axial components of gas velocity were derived based on them. The results obtained are compared with the results of numerical simulation. The latter was carried out in the FlowVision software using the SST turbulence model. Via numerical calculations the change in the tangential and axial components of the gas velocity was determined at distances of 110, 150, 200, and 250 mm from the plate turbulator, or cyclone swirler.

Publisher

The Russian Academy of Sciences

Reference32 articles.

1. Cristobal C., Gil A. Modeling the gas and particle flow inside cyclone separators // Progress Energy Combust. 2007. V. 33 N 5. P. 409-452. https://doi.org/10.1016/j.pecs.2007.02.001

2. Peng W., Hoffmann A. C., Dries H. W.-A., Regelink M. A., Stein L. E. Experimental study of the vortex-end in centrifugal separators: The Nature of the vortex end // Chem. Eng. Sci. 2005. V. 60. P. 6919-692828. https://doi.org/10.1016/j.ces.2005.06.009

3. Biegger C., Sotgiu C., Weigand B. Numerical investigation of flow and heat transfer in a swirl tube // Int. J. Therm. Sci. 2015. V. 96. P. 319-330. https://doi.org/10.1016/j.ijthermalsci.2014.12.001

4. Seibold F., Weigand B. Numerical analysis of the flow pattern in convergent vortex tubes for cyclone cooling applications // Int. J. Heat Fluid Flow. 2021. V. 90. https://doi.org/10.1016/j.ijheatfluidflow.2021.108806

5. Bruschewski M., Grundmann S. Schiffer H.-P. Considerations for the design of swirl chambers for the cyclone cooling of turbine blades and for other applications with high swirl intensity // Int. J. Heat Fluid Flow. 2020. V. 86. ID 108670. https://doi.org/10.1016/j.ijheatfluidflow.2020.108670