Quantification of Large Deformation with Punching in Dual Phase Steel and Change of its Microstructure –Part I: Proposal of the Quantification Technique of the Punching Damage of the Dual Phase Steel-Reference-Cited by-同舟云学术

Quantification of Large Deformation with Punching in Dual Phase Steel and Change of its Microstructure –Part I: Proposal of the Quantification Technique of the Punching Damage of the Dual Phase Steel

Published:2016 Issue:11 Volume:56 Page:2068-2076
ISSN:0915-1559
Container-title:ISIJ International
language:en
Short-container-title:ISIJ Int.

Author:

Yokoi Tatsuo¹,Shuto Hiroshi¹,Ikeda Ken-ichi²,Nakada Nobuo³,Tsuchiyama Toshihiro⁴,Ohmura Takahito⁵,Mine Yoji⁶,Takashima Kazuki⁶

Affiliation:

1. Oita R & D Lab. Technical Research & Development Bureau NIPPON STEEL & SUMITOMO METAL Corp.

2. Division of Materials Science and Engineering, Faculty of Engineering, Hokkaido University

3. Department of Materials Science and Engineering, School of Materials and Chemical Technology, Tokyo Institute of Technology

4. Department of Materials Science and Engineering, Faculty of Engineering, Kyushu University

5. Research Center for Strategic Materials, National Institute for Materials Science

6. Department of Materials Science and Engineering, Kumamoto University

Publisher

Iron and Steel Institute of Japan

Subject

Materials Chemistry,Metals and Alloys,Mechanical Engineering,Mechanics of Materials

Link

https://www.jstage.jst.go.jp/article/isijinternational/56/11/56_ISIJINT-2016-312/_pdf

Reference38 articles.

1. 1) Y. Kuriyama, M. Takahashi and H. Ohashi: J. Soc. Automotive Eng. Jpn., 55 (2001), 51.

2. 2) T. Senuma and M. Takahashi: Materia Jpn., 44 (2005), 488.

3. 3) Y. Tomota, K. Kuroki and I. Tamura: Tetsu-to-Hagané, 61 (1975), 107.

4. 4) Y. Tomota and K. Kuroki: Mater. Sci. Eng., 24 (1976), 85.

5. 5) K. Araki, Y. Takada and K. Nakaoka: Trans. Iron Steel Inst. Jpn., 17 (1977), 710.

Cited by 11 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Quantitative Characterization of the Affected Zones in a Single Crystal Fe-6Si Steel Sheet by Fine Piercing;Micromachines;2022-03-31

2. Hole Expansion Test and Characterization of High-Strength Hot-Rolled Steel Strip;Transactions of the Indian Institute of Metals;2021-11-06

3. Investigation of the critical factors controlling sheared edge stretching of ultra-high strength dual-phase steels;Materials Science and Engineering: A;2021-11

4. Local hydrogen accumulation after cold forming and heat treatment in punched advanced high strength steel sheets;Journal of Alloys and Compounds;2021-03

5. THE EFFECT OF PUNCH GEOMETRY ON PUNCHING PROCESS IN TITANIUM SHEET;Jurnal Teknologi;2020-02-04