Breakage Monitoring of Executive Body Cutters in Continuous Miner According to Mechanical Vibration Parameters. Part 1. Research Methodology

Abstract

Vibromonitoring is the most methodologically developed and technically equipped with recording tools and data processing approach. However, in the sources of scientific and technical information about mining it is presented much less than other monitoring methods. One of the promising ways to solve this problem, in particular monitoring the breakage of cutting disc cutters of an executive body, is to use parameters of natural oscillations of the parts of gearboxes that occur during impulse loading due to such breakages. It should be noted that in the technically complex equipment of the mining industry, in particular in mining machines, there are many sources of vibration, the vibtaions of which are superimposed on each other. And it is not always possible to isolate and identify the required informative signal with the source. With this in mind the paper presents a research methodology on the possibility of monitoring the breakage of the executive body cutters on the example of the continuous miner “Universal 600” according to the parameters of natural vibrations of the executive body cutting discs arising from the breakage of the cutters. The place of registration of these vibrations is determined – the gearbox handles, on the output shafts of which cutting discs are placed. The frequency of such vibrations is set equal to ~5 Hz. The possibility of using the AGAT-M vibration analyzer with M/AC102-1A vibration sensors as a means of further research has been substantiated in the paper. The paper considers an option of placing vibration sensors on non-rotating gear housings of the executive body drive. An algorithm for recording vibration parameters has been developed, which makes it possible to separate its sources.