Author:
Morsi Nour M.,Mata Mario,Harrison Colin S.,Semple David
Abstract
Introduction: Robotics uptake in the aerospace industry is low, mainly due to the low-volume/high-accuracy production that aerospace manufacturers require. Furthermore, aerospace manufacturing and assembly sites are often unstructured environments not specifically suitable for robots to operate in.Methods: This paper introduces a robotic visual inspection system using off-the-shelf components able to inspect the mounting holes for wing slat actuators without the need for fixed-coordinate programming; the part just needs to be left within reach of the robot. Our system sets one of the opposed pairs of mounting holes as a reference (the “datum”) and then compares the tilt of all other pairs of mounting holes with respect to it. Under the assumption that any deviation in the mounting hole tilt is not systematic but due to normal manufacturing tolerances, our system will either guarantee the correct alignment of all mounting holes or highlight the existence of misaligned holes.Results and Discussion: Computer-vision tilt measurements are performed with an error of below 0.03° using custom optimization for the sub-pixel determination of the center and radius of the mounting holes. The error introduced by the robot’s motion from the datum to each of the remaining hole pairs is compensated by moving back to the datum and fixing the orientation again before moving to inspect the next hole pair. This error is estimated to be approximately 0.05°, taking the total tilt error estimation for any mounting hole pair to be 0.08° with respect to the datum. This is confirmed by manually measuring the tilt of the hole pairs using a clock gauge on a calibrated table (not used during normal operation).
Reference60 articles.
1. A review: drilling performance and hole quality of aluminium alloys for aerospace applications;Aamir;J. Mater. Res. Technol.,2020
2. Detection of road potholes using computer vision and machine learning approaches to assist the visually challenged;Akshaya Devi,2023
3. Angle of view;Allgaier,2011
4. A survey on inspecting structures using robotic systems;Almadhoun;Int. J. Adv. Robotic Syst.,2016
5. Smart industrial robot control trends, challenges and opportunities within manufacturing;Arents;Appl. Sci.,2022