Abstract
This paper is aimed at assessing in-service asphalt pavement cracking in order to fully understand its causes as well as reviewing the possible impact of implementing a new mix design method on failures observed. Field and laboratory investigations were conducted as well as a review of design and construction records. Substitution of a Performance Grade (PG) binder with straight run pen grade binder without performing independent Superpave PG verification tests greatly contributed to cracking. A 20/30 pen grade binder which was utilised had already undergone some change in its properties since its manufacture and therefore did not provide the required workability and crack resistance that it would otherwise have been expected to provide. Target mixing and compaction temperature ranges during construction were higher than those recommended confirming that the binder used had already undergone a change in its physical and chemical characteristics between the time of its manufacture and use. Additionally, a lapse in quality control and assurance during asphalt production and laying resulted in a highly voided wearing course which exacerbated the situation.
Subject
Management, Monitoring, Policy and Law,Renewable Energy, Sustainability and the Environment,Geography, Planning and Development
Reference37 articles.
1. Effects of overheating bitumen on hot mix asphalt properties;Salleh;J. Online Jar. Pengaj. Seni Bina (JOJAPS),2012
2. Influence of High-Temperature Volatilization on Performance of Bituminous Binder
Cited by
9 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献