Array Design of 300 GHz Dual-Band Microstrip Antenna Based on Dual-Surfaced Multiple Split-Ring Resonators

Abstract

To meet the increasing need of high-data-rate and broadband wireless communication systems, the devices and its circuits R&D under Millimeter, Sub-Millimeter, or even Terahertz (THz) frequency bands are attracting more and more attention from not only academic, but also industrial areas. Most of the former research on the THz waveband (0.1–10 THz) antenna design is mainly focused on realizing high directional gain, such as horn antennas, even though the coverage area is very limited when comparing with the current Wi-Fi system. One solution for the horizontally omnidirectional communication antenna is using the structure of multiple split-ring resonators (MSRRs). Aiming at this point, a novel 300 GHz microstrip antenna array based on the dual-surfaced multiple split-ring resonators (DSMSRRs) is proposed in this paper. By employing the two parallel microstrip transmission lines, different MSRRs are fed and connected on two surfaces of the PCB with a centrally symmetric way about them. The feeding port of the whole antenna is in between the centers of the two microstrip lines. Thus, this kind of structure is a so-called DSMSRR. Based on the different size of the MSRRs, different or multiple working wavebands can be achieved on the whole antenna. Firstly, in this paper, the quasi-static model is used to analyze the factors affecting the resonance frequency of MSRRs. Simulation and measured results demonstrate that the resonant frequency of the proposed array antenna is 300 GHz, which meets the design requirements of the expected frequency point and exhibits good radiation characteristics. Then, a dual-band antenna is designed on the above methods, and it is proved by simulation that the working frequency bands of the proposed dual-band antenna with reflection coefficient below −10 dB are 274.1–295.6 GHz and 306.3–313.4 GHz.