Settlement of Soil Reinforced with Vertical Fiberglass Micro-Piles

Abstract

This article is dedicated to investigating the properties of soil after its reinforcement with fiberglass elements through large-scale laboratory plate-load tests of various samples that varied in the numbers and lengths of the reinforcing elements. The investigation of the vertical elements considered the diameter increase at the bottom toe by using widening washers. The results were compared relative to each other and to the theoretical calculation results. The theoretical calculations for the settlements were undertaken based on the authors’ proposed method. The method considers the number, shape, area and material of the strengthening elements using a pre-proposed reinforcement area factor µ. This pre-established factor was calculated with reference to the elements’ geometry—the diameter of the vertical elements and the bottom’s washer diameter—which determined the reinforcement area. A comparison between the reinforced and reference soft sandy soil samples indicated a 25% increase in the deformation modulus after the reinforcement process at a pressure of 25 kPa. Samples with µ ranging from 1.20 to 1.43 were 55–65% stiffer than samples with µ equal to 0.69 at a pressure of 100 kPa. The comparative analysis of the calculated results and the actual laboratory PLT test results was adequate for use for further development.