Removal of Sulphate Ions from Borehole Water Using Nanofiltration and Reverse Osmosis

Abstract

Consumption of contaminated water poses health hazards to humanity and hence increases the need for treatment. An excessive level of sulphate in borehole water was detected in the drinking water supply of Garpéné village in Burkina Faso. This study aimed to evaluate the performance of nanofiltration and reverse osmosis for the removal of sulphate ions from borehole water. A combined nanofiltration and reverse osmosis pilot was used for the treatment of the raw borehole water and some prepared synthetic solutions. Different experimental conditions were used to evaluate the effects of the pressure, the nature of the solution to be filtered, and the ions accompanying the sulphate. The filtration tests were conducted at transmembrane pressures of 1, 2.5 and 4 bar with a nanofiltration NF270 membrane and at transmembrane pressures of 4, 6 and 8 bar with a reverse osmosis TW30 membrane. The membrane used were a thin-film composite (TFC) membrane from Filmtec. The pilot was fed with real water from the Garpéné borehole and synthetic solutions of calcium sulphate and sodium sulphate at three different concentrations (250, 500 and 1400 mg/L). The results demonstrated that the nanofiltration and reverse osmosis membranes achieved retention rates of sulphate ions ranging from 97.0% to 98.7% and 98.4% to 99.0%, respectively. The results also showed that the operating conditions had a significant effect on the retention of sulphate by reverse osmosis and nanofiltration membranes. With regard to the effect of the counter ion, it was observed that during nanofiltration, the retention rate of sulphate ions in the water to be treated was lower in the presence of calcium ions than that of sodium ions, whereas in reverse osmosis little influence of the counter ion was observed.