Affiliation:
1. Department of Electrical Engineering, National Taiwan University of Science and Technology, Taipei 10607, Taiwan
2. National Atomic Research Institute, Taoyuan City 32546, Taiwan
Abstract
Partial discharge (PD) characteristics are very important for the diagnosis of damaged transformation equipment. If the power transmission and transformation equipment fails, it will cause large economic losses, and thus prevention is better than treatment. One of the effective methods for high-voltage insulation degradation detection is to observe the phenomenon of partial discharge of equipment, which is the earliest characteristic. Prevention can be carried out in advance, and trend observation is better than periodic inspection. Long-term observation can effectively reduce the probability of misjudgment. This project intends to develop a high-speed data-acquisition device to acquire the original discharge waveform data of partial discharge for noise suppression. In order to improve the diagnostic efficiency and accuracy of the diagnostic system, it is necessary to suppress the noise of the measurement data, so as to carry out the fault identification of the discharge type. Through this method, the actual operating data of the system can be recorded as the original discharge waveform, in order to understand the original discharge waveform conditions of the power transmission and transformation equipment in multiple partial discharge measurements, and then after noise suppression, it can be regarded as a type of partial discharge identification.