Chitosan/Sodium Alginate Hydrogel for the Release of Berberine as an Algae Suppressant: RSM Optimization and Analysis of Sustained Release Characteristics

Abstract

In this study, we used chitosan/sodium alginate hydrogel as a carrier to prepare berberine sustained-release capsule materials that can inhibit algae for a long time and safely. The preparation conditions of the material were optimized by the response surface method, and the optimized capsule material was characterized and the sustained release characteristics were analyzed to study the change of the algae inhibition effect of the material within 30 days. The results showed that the optimum preparation parameters of the material were 0.54% chitosan content, 2.46% sodium alginate content and 1.09% anhydrous calcium chloride content by response surface optimization design, which was consistent with the parameters set by each factor at the central point. The algae inhibition rate of the material under this preparation condition was 93.75 ± 1.01%, which was similar to the predicted value. The release characteristics analysis showed that the material continuously released up to 90% of berberine within 24 days, and its release characteristics were sustained release after burst release, with good sustained release effect. The results of material characterization showed that chitosan/sodium alginate hydrogel could effectively load berberine and was beneficial to the loading and release of berberine. The results of algae inhibition experiments showed that low concentration materials could control the outbreak of cyanobacterial blooms in a short time, while under high concentration conditions, the materials could inhibit Microcystis aeruginosa efficiently and for a long time.