Affiliation:
1. Faculty of Civil Engineering, Silesian University of Technology, 44-100 Gliwice, Poland
Abstract
The research presented in this article was conducted to evaluate the suitability of recycled foam concrete (RFC) as an ingredient in newly created cement mortars. The basis for an analysis was the assumption that the waste is collected selectively after separation from other waste generated during demolition. The motivation for the research and its main problem is a comparison of the performance of RFC used in various forms. RFC was used in two forms: (1) recycled foam concrete dust (RFCD) as a 25 and 50% replacement of cement, and (2) recycled foam concrete fine aggregate (RFCA) as a 10, 20, and 30% replacement of sand. The basic properties of fresh and hardened mortars were determined: consistency, density, initial setting time, absorbability, compressive strength, thermal conductivity coefficient, and heat capacity. Research is complemented with SEM observations. The properties of fresh mortars and mechanical parameters were decreased with the usage of any dosage of RFC in any form, but the thermal properties were improved. The required superplasticizer amount for proper consistency was raised four times for replacing cement with 50% of RFCD than for 25% of such replacement. The mix density dropped by about 8% and 9% for mortars with the replacement of 50% cement by RFCD and 30% sand by RFCA in comparison to reference mortar. A 30% decrease in initial setting time was observed for cement replacement. In the case of sand replacement, it was the opposite—an increase of 100%. The dry density decreased by about 14% and 11% for mortars with the replacement of 50% cement by RFCD and 30% sand by RFCA in comparison to reference mortar. Absorbability was raised by about two times after replacement with both RFCD and RFCA. Compressive strength after 28 days dropped significantly by 75% and 60%, and the thermal conductivity coefficient decreased by 20% and 50% with 50% RFCD added instead of cement and 30% RFCA replacing sand. It indicates greater efficiency in thermomechanical means from RFCA in comparison to RFCD. This material can be used especially in the production of plaster and masonry mortar. Linear correlations of dry density and thermal conductivity coefficient and the latter and compressive strength were proven as reliable for RFCD replacement of cement and RFCA replacement of sand in mortars with greater w/c ratio.
Funder
Silesian University of Technology
Subject
General Materials Science
Reference72 articles.
1. (2023, October 12). 2022 Global Status Report for Buildings and Construction|UNEP—UN Environment Programme. Available online: https://www.unep.org/resources/publication/2022-global-status-report-buildings-and-construction.
2. U.S. Geological Survey (2023, November 09). Mineral Commodity Summaries 2022—Cement, Available online: https://pubs.usgs.gov/periodicals/mcs2022/mcs2022-cement.pdf.
3. Lehne, J., and Preston, F. (2018). Making Concrete Change: Innovation in Low-Carbon Cement and Concret, Chatham House—International Affairs Think Tank.
4. Lehner, P., Horňáková, M., Pizoń, J., and Gołaszewski, J. (2022). Effect of Chemical Admixtures on Mechanical and Degradation Properties of Metallurgical Sludge Waste Concrete. Materials, 15.
5. Recycle Option for Metallurgical Sludge Waste as a Partial Replacement for Natural Sand in Mortars Containing CSA Cement to Save the Environment and Natural Resources;Alwaeli;J. Hazard. Mater.,2020