Analysis of Uneven Wear Mechanism of Narrow-Face Copper Wall of Funnel Mold

Abstract

In thin-slab continuous casting, due to the influence of the special shape of the funnel mold, cracks at the corner of the slab shell are more likely to occur than those in conventional slab shells, and a serious wear phenomenon also appears on the narrow face of the copper wall of the mold. Aimed at the corner cracks of thin slabs and the wear phenomenon of the copper wall, a new 3D stress analysis model in a funnel mold has been developed to simulate the stress-–train behavior of the slab shell under high-speed continuous casting. The results show that at the position 600 mm below the meniscus, the gap begins to appear at the corner of the slab; the maximum value of the first principal stress appears at the corner. The shell is squeezed by the copper wall during the downward movement in the funnel mold, and the slab shell in the funnel area moves towards the narrow face. The displacement causes the deformation of the slab shell to extend to the corners, the deformed shell is pressed against the corner of the copper wall. A new type of copper wall was designed for production, and it was found that the cracks at the corner of the slab shell were greatly reduced.