Design, Manufacture and Wind Tunnel Test of a Modular FishBAC Wing with Novel 3D Printed Skins

Abstract

This paper introduces a new modular Fish Bone Active Camber morphing wing with novel 3D printed skin panels. These skin panels are printed using two different Thermoplastic Polyurethane (TPU) formulations: a soft, high strain formulation for the deformable membrane of the skin, reinforced with a stiffer formulation for the stringers and mounting tabs. Additionally, this is the first FishBAC device designed to be modular in its installation and actuation. Therefore, all components can be removed and replaced for maintenance purposes without having to remove or disassemble other parts. A 1 m span, 0.27 m chord morphing wing with a 25% chord FishBAC was built and tested mechanically and in a low-speed wind tunnel. Results show that the new design is capable of achieving the same large changes in airfoil lift coefficient (approximate ΔCL≈0.55) with a low drag penalty seen in previous FishBAC work, but with a much simpler, practical and modular design. Additionally, the device shows a change in the pitching moment coefficient of ΔCM≈0.1, which shows the potential that the FishBAC has as a control surface.