Effects of Heat Treatment on the Microstructure and Properties of a Cast Nickel-Based High-Cr Superalloy

Abstract

The effect of solution treatment and intermediate heat treatment on the microstructure and properties of a new cast nickel-based high-Cr superalloy was investigated in this paper. The results indicate that the tensile strength and elongation at 900 °C increase when the solution temperature increases from 1160 °C to 1180 °C and then decrease when the solution temperature changes from 1180 °C to 1200 °C and 1220 °C. The stress rupture test results of the high-Cr superalloy under conditions of 900 °C/275 MPa shows that the rupture time, elongation, and reduction of area initially increased and then decreased with the increase in solution treatment temperatures. The results of stress rupture tests for the alloy after intermediate heat treatment followed by furnace-cooling, air-cooling, and water-cooling show that the morphology and distribution of γ’ phase have a great influence on the tensile test results at 900 °C of the alloy but no obvious influence on the test at 900 °C/275 MPa. The microstructure analysis of the superalloy after heat treatment shows that: when the solution treatment temperatures are at 1200 °C and 1220 °C, the incipient melting appears in the interdendritic region, which can severely deteriorate mechanical properties; the morphology of γ′ phase changes gradually from cube to spherical; and a large number of fine γ’ phase precipitates in the γ channel are found with increasing cooling rate after intermediate heat treatment.