Abstract
Mechanical properties of rock masses are dominated by the nonlinear response of joints and their arrangement. In this paper, combined influences of joint spacing (s) and joint inclination angle (β) on mechanical behavior of rock mass models with large open joints under uniaxial compression were investigated by PFC modeling. With a large amount of local measurement circles placed along the pre-defined measurement lines (ML), stresses and joint response parameters at different scales (the measurement circles, the MLs and the whole specimen) were defined and calculated. It was found that macroscopic behaviors of the jointed specimens, such as four types of deformation behaviors, four failure modes, strength, deformability modulus and ductility index, are dominated by nonlinear response of the joint system, especially the interaction between the joints and rock bridges. The joints may experience three stages, i.e., starting to close, closed and opening again. On the joint plane, the peak stresses of the rock bridges and those of the joints may not be reached at the same time; i.e., joint strength mobilization happens with the loss of the rock bridges’ resistance. The influence of s on specimen behavior is little for β = 90°, obvious for β = 0° or 30° and significant for β = 45° or 60°, and this can be related to their different microscopic damage mechanisms.
Subject
Energy (miscellaneous),Energy Engineering and Power Technology,Renewable Energy, Sustainability and the Environment,Electrical and Electronic Engineering,Control and Optimization,Engineering (miscellaneous)
Cited by
3 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献