Characteristics of Suspended Road Dust According to Vehicle Driving Patterns in an Urban Area and PM10 Content in Silt

Abstract

Characterizing the influence factors of exhaust gas based on the suspended road dust on paved roads, according to the number of vehicles and their distance with regard to driving pattern, is important in order to provide a coefficient for driving patterns to find a model equation. This has been a limitation of previous studies, in which this was difficult to carry out in a large area reflecting various driving patterns because some sections were selected according to empirical measurement results, and only one vehicle measurement was used to find the level of road dust. This study measured the concentration of suspended road dust that could occur, depending on the vehicle’s driving patterns, on an experimental road in Yongin, South Korea, from May to July 2023. The study was conducted to determine the degree of the effect of exhaust gas, according to the concentration of suspended road dust generated, by determining the separation distance based on real-time measurements. This study attempted to determine the changes in suspended road dust based on driving patterns in urban areas and factor in the concentration of suspended road dust with regard to emission characteristics in terms of exhaust gas and particulate matter with a diameter of 10 microns or less (PM10). This was in accordance with conditions evaluated using mobile laboratories, based on suspended-PM10-concentration-measuring equipment. This study mainly focused on the following main topics: (1) increasing the level of suspended particulate matter at less than 10 m intervals produced by exhaust gas; (2) decreasing the level of suspended road dust with an increase in the number of vehicles, with the area measured at a distance of three cars in front showing the lowest level of suspended road dust in the air and a low level for the rear vehicle; (3) demonstrating that PM10 is effective in measuring the generation of suspended road dust; and (4) evaluating suspended road dust levels by road section. Based on the results, this research is necessary to more appropriately set the focus of analyses that aim to characterize suspended road dust according to exhaust gas and PM10 content in silt.