Influence of Medial Osteotomy Height and Hinge Position in Open Wedge High Tibial Osteotomy: A Simulation Study

Abstract

(1) Background: In treating medial unicompartmental gonarthrosis, medial open wedge high tibial osteotomy (mOWHTO) reduces pain and is intended to delay a possible indication for joint replacement by relieving the affected compartment. This study aimed to investigate the influence of the osteotomy height with different hinge points in HTO in genu varum on the leg axis. (2) Methods: Fifty-five patients with varus lower leg alignment obtained full-weight bearing long-leg radiographs were analyzed. Different simulations were performed: Osteotomy height was selected at 3 and 4 cm distal to the tibial articular surface, and the hinge points were selected at 0.5 cm, 1 cm, and 1.5 cm medial to the fibular head, respectively. The target of each correction was 55% of the tibial plateau measured from the medial. Then, the width of the opening wedge was measured. Intraobserver and interobserver reliability were calculated. (3) Results: Statistically significant differences in wedge width were seen at an osteotomy height of 3 cm below the tibial plateau when the distance of the hinge from the fibular head was 0.5 cm to 1.5 cm (3 cm and 0.5 cm: 8.9 +/− 3.88 vs. 3 cm and 1.5 cm: 11.6 +/− 4.39 p = 0.012). Statistically significant differences were also found concerning the wedge width between the distances 0.5 to 1.5 cm from the fibular head at the osteotomy height of 4 cm below the tibial plateau. (4 cm and 0.5 cm: 9.0 +/− 3.76 vs. 4 cm and 1.5 cm: 11.4 +/− 4.27 p = 0.026). (4) Conclusion: A change of the lateral hinge position of 1 cm results in a change in wedge width of approximately 2 mm. If hinge positions are chosen differently in preoperative planning and intraoperatively, the result can lead to over- or under-correction.