Microstructural and Mechanical Characterization of the Aging Response of Wrought 6156 (Al-Mg-Si) Aluminum Alloy

Abstract

The impact of the artificial aging response on the microstructure and tensile mechanical properties of aluminum alloy 6156 was investigated. Specimens were artificially aged at three different artificial aging temperatures and for various holding times to investigate all possible aging conditions, including the under-aged (UA), peak-aged (PA) and over-aged (OA) tempers. Microstructural investigation as well as tensile tests were performed immediately after the isothermal artificial aging heat treatment. An almost 50% increase in yield stress (around 340 MPa) was noticed in the PA temper and this was attributed to the precipitation of β′ and Q′ phases, consistent with the modelling predictions. This high yield stress value is accompanied by high values of elongation at fracture (>10%) that is essential for damage tolerance applications. The lack of large or interconnected grain boundary precipitates contributes to this high elongation. Slanted fracture was noticed for both UA and PA tempers, exhibiting a typical ductile and shear fracture mechanism. At the OA temper, coarsening of the precipitates along with broadening of the precipitate free zones resulted in a reduction in the strengthening effectiveness of the precipitates, and a small increase in the tensile ductility of approximately 12% was noticed.