Affiliation:
1. Department of Reinforced Concrete and Masonry Structures, Institute of Civil Engineering, National Research Moscow State University of Civil Engineering, Moscow 129337, Russia
2. Department of Civil Engineering, Mytishchi Branch of National Research Moscow State University of Civil Engineering, National Research Moscow State University of Civil Engineering, Moscow 129337, Russia
Abstract
A possible way to improve the structural safety and robustness of precast building structures is to develop effective precast frame systems with layered beams, which combine prefabricated parts with cast-in situ ordinary concrete, high-performance concrete, fiber concrete, or FRP. The paper provides a new type of precast reinforced concrete frame system with layered beams for rapidly erected multi-story buildings resistant to accidental actions. Using a combination of the variational method and two-level design schemes, a simplified analytical model has been developed for structural analysis of the precast reinforced concrete frame system, both for serviceable and ultimate limit states as well as for accidental actions. The proposed model allows for determining shear deformations and the formation and opening of longitudinal cracks in the intermediate contact zone between precast and monolithic parts of reinforced concrete structural elements of the frame, as well as the formation and opening of normal cracks because of the action of axial tensile force or bending moment in these elements. The design model was validated by comparing the calculated and experimental data obtained from testing scaled models of the precast reinforced concrete frame system with layered beams. The paper investigates and thoroughly analyzes the factors affecting the stiffness and bearing capacity of the intermediate contact zone, discusses the criteria for the formation of shear cracks along the contact zone of precast and monolithic concrete, and examines the change in the stiffness and dissipative properties of layered elements at different stages of their static–dynamic loading. The robustness of the experimental models of the structural system was not ensured under the specified load, section dimensions, and reinforcement scheme. Following an accidental action, longitudinal cracks were observed in the contact joint between the monolithic and prefabricated parts in the layered beams. This occurred almost simultaneously with the opening of normal cracks in adjacent sections. A comprehensive analysis of the results indicated a satisfactory degree of agreement between the proposed semi-analytical model and the test data.
Funder
National Research Moscow State University of Civil Engineering
Reference57 articles.
1. Ronan Point Apartment Tower Collapse and Its Effect on Building Codes;Pearson;J. Perform. Constr. Facil.,2005
2. Tagel-Din, H., and Rahman, N.A. (April, January 29). Simulation of the Alfred P. Murrah Federal Building Collapse Due to Blast Loads. Proceedings of the AEI 2006: Building Integration Solutions—Proceedings of the 2006 Architectural Engineering National Conference, Omaha, NE, USA.
3. Long Span Buildings Analysys under Phisical, Geometic and Structural Nonlinearities Consideration;Belostotsky;Int. J. Comput. Civ. Struct. Eng.,2010
4. Learning from the Progressive Collapse of Buildings;Caredda;Dev. Built Environ.,2023
5. Research and Practice on Progressive Collapse and Robustness of Building Structures in the 21st Century;Adam;Eng. Struct.,2018
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献