Abstract
Metal sheets have good performance and have been widely used. Different kinds of defects can be generated during the preparation and service of metal plates, which will cause the structural performance of the metal plates to decline, thus requiring structural health monitoring (SHM). This study proposes an electromagnetic ultrasonic (EMUS) surface wave detection technique for metal sheet defects via simulation. The numerical results show that after the excitation parameters of the EMUS transducer are optimized through orthogonal experimental design, the amplitude of the EMUS signal generated is increased by about 80%. The power spectrum density (PSD) of the EMUS response signal is used to detect defects. Compared with the peak-to-peak detection, the accuracy is higher, and the reliability is better. The accuracy of the proposed “central zero-point” method for measuring the time delay of the EMUS signal wave packet is higher than that of the “peak-to-peak amplitude” method and the “vibration starting point” method and is close to the accuracy of the “cross-correlation” method.
Funder
MOE Key Laboratory of High-Speed, Railway Engineering, Southwest Jiaotong University
Subject
Building and Construction,Civil and Structural Engineering,Architecture
Reference26 articles.
1. Health Monitoring of Aerospace Structures: Smart Sensor Technologies and Signal Processing;Staszewski,2004
2. Application of ultrasonic waves to defect inspection of large thin plate;Zhou;Acta Aeronaut. Astronaut. Sin.,2008
3. Development status of surface defects inspection for metal plants;Li;Mater. Rev.,2011
4. Milling surface roughness for 7050 aluminum alloy cavity influenced by nozzle position of nanofluid minimum quantity lubrication
5. On the correlation between microstructural evolution and ultrasonic properties: a review
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献