Optimized Sensors Network and Dynamical Maps for Monitoring Traffic Noise in a Large Urban Zone

Abstract

We review a Dynamap European Life project whose main scope was the design, commissioning, and actual implementation of “real-time” acoustic maps in a district of the city of Milan (District 9, or Z9, composed of about 2000 road stretches), by employing a small number of noise monitoring stations within the urban zone. Dynamap is based on the idea of finding suitable sets of roads displaying similar daily traffic noise behavior, so that one can group them together into single dynamical noise maps. The Dynamap sensor network has been built upon twenty-four monitoring stations, which have been permanently installed in appropriate locations within the pilot zone Z9, by associating four sensors to each one of the six group of roads considered. In order to decide which road stretches belong to a group, a non-acoustic parameter is used, which is obtained from a traffic flow model of the city, developed and tested over the years by the “Enviroment, Mobility and Territory Agency” of Milan (EMTA). The fundamental predictive equation of Dynamap, for the local equivalent noise level at a given site, can be built by using real-time data provided by the monitoring sensors. In addition, the corresponding contributions of six static traffic noise maps, associated with the six group of roads, are required. The static noise maps can be calculated from the Cadna noise model, based on EMTA road traffic data referred to the ‘rush-hour’ (8:00–9:00 a.m.), when the road traffic flow is maximum and the model most accurate. A further analysis of road traffic noise measurements, performed over the whole city of Milan, has provided a more accurate description of road traffic noise behavior by using a clustering approach. It is found that essentially just two mean cluster hourly noise profiles are sufficient to represent the noise profile at any site location within the zone. In order words, one can use the 24 monitoring stations data to estimate the local noise variations at a single site in real time. The different steps in the construction of the network are described in detail, and several validation tests are presented in support of the Dynamap performance, leading to an overall error of about 3 dB. The present work ends with a discussion of how to improve the design of the network further, based on the calculation of the cross-correlations between monitoring stations’ noise data.