A dToF Ranging Sensor with Accurate Photon Detector Measurements for LiDAR Applications
Author:
Yu Hengwei1ORCID, Wang Long2, Xu Jiqing1ORCID, Chiang Patrick Yin1
Affiliation:
1. State Key Laboratory of ASIC & System, Fudan University, Shanghai 201203, China 2. PhotonIC Technologies, Shanghai 201203, China
Abstract
Direct time-of-flight (dToF) ranging sensors based on single-photon avalanche diodes (SPADs) have been used as a prominent depth-sensing devices. Time-to-digital converters (TDCs) and histogram builders have become the standard for dToF sensors. However, one of the main current issues is the bin width of the histogram, which limits the accuracy of depth without TDC architecture modifications. SPAD-based light detection and ranging (LiDAR) systems require new methods to overcome their inherent drawbacks for accurate 3D ranging. In this work, we report an optimal matched filter to process the raw data of the histogram to obtain high-accuracy depth. This method is performed by feeding the raw data of the histogram into the different matched filters and using the Center-of-Mass (CoM) algorithm for depth extraction. Comparing the measurement results of different matched filters, the filter with the highest depth accuracy can be obtained. Finally, we implemented a dToF system-on-chip (SoC) ranging sensor. The sensor is made of a configurable array of 16 × 16 SPADs, a 940 nm vertical-cavity surface-emitting laser (VCSEL), an integrated VCSEL driver, and an embedded microcontroller unit (MCU) core to implement the best matched filter. To achieve suitably high reliability and low cost, the above-mentioned features are all packaged into one module for ranging. The system resulted in a precision of better than 5 mm within 6 m with 80% reflectance of the target, and had a precision better than 8 mm at a distance within 4 m with 18% reflectance of the target.
Funder
Science and Technology Commission of Shanghai Municipality
Subject
Electrical and Electronic Engineering,Biochemistry,Instrumentation,Atomic and Molecular Physics, and Optics,Analytical Chemistry
Reference21 articles.
1. Warren, M.E. (2019, January 9–14). Automotive LIDAR technology. Proceedings of the 2019 Symposium on VLSI Circuits, Kyoto, Japan. 2. Anthony, W.Y., Troupaki, E., Li, S.X., Coyle, D.B., Stysley, P., Numata, K., Fahey, M.E., Stephen, M.A., Chen, J.R., and Yang, G. (October, January 26). Orbiting and in situ Lidars for earth and planetary applications. Proceedings of the IGARSS 2020-2020 IEEE International Geoscience and Remote Sensing Symposium, Waikoloa, HI, USA. 3. CMOS SPADs: Design issues and research challenges for detectors, circuits, and arrays;Palubiak;IEEE J. Sel. Top. Quantum Electron.,2014 4. Villa, F., Severini, F., Madonini, F., and Zappa, F. (2021). SPADs and SiPMs arrays for long-range high-speed light detection and ranging (LiDAR). Sensors, 21. 5. Tontini, A., Gasparini, L., and Perenzoni, M. (2020). Numerical model of SPAD-based direct time-of-flight flash lidar CMOS image sensors. Sensors, 20.
|
|