Abstract
In order to obtain better cutting tool performance, the coatings appear as an alternative in the machining process. The goal of the coating is to improve tribological conditions in the chip-tool and tool-workpiece interfaces. On the other hand, the use of coated tools decreases the wear of the tools. This study discusses the ceramic coatings characterization deposited in WC tools. The Al2O3 and TiO2 films present properties such as thermal stability, chemical inertia, high hardness, and good mechanical properties. These coatings were prepared by sol-gel technology. The results indicated that the multilayer coating presents better adhesion on the substrate. Moreover, lower coefficients of friction were found for the coated tools. The analysis of variance (ANOVA) was used to evaluate the influence of the cutting parameters and tool coating on the cutting force. The lower cutting force was obtained using the multilayer-coated tool. Thus, the sol-gel method appears as a novel technique to deposit coating in the WC tools to improve their performance.
Subject
Materials Chemistry,Surfaces, Coatings and Films,Surfaces and Interfaces
Cited by
11 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献