Effectiveness of Porcelain Polishing Methods on the Roughness and Color Stability of CAD–CAM Ceramics after Orthodontic Bracket Debonding

Abstract

Increased utilization of all ceramic restorations for aesthetic consideration in combination with routine adult orthodontic practice has led to numerous clinical challenges. Obtaining adequate bond strength between the orthodontic bracket and all-ceramic restoration and damage to the ceramic surface during the bracket debonding procedure needs to be better understood. This study analyzed the surface texture and color change of glazed and bracket-debonded ceramic CAD–CAM materials and the efficiency of porcelain polishing systems in restoring surface morphology and color. A total of 30 rectangular test specimens from each lithium disilicate CAD (LD-CAD), polymer-infiltrated ceramic (PICN), zirconia-reinforced lithium silicate glass ceramic (ZLS), and 5YTZP zirconia (5YZP) were prepared. The ceramic samples were embedded within acrylic resin, and baseline surface roughness and color were recorded using an optical profilometer and a reflected color spectrophotometer. The porcelain samples were bonded with lower incisor ceramic brackets. The samples were thermocycled 2000 times between 5 and 55 °C. Afterward, the brackets were peeled with bracket-removing pliers. The resin adhesive from the debonded surface was eliminated with tungsten carbide bur, and samples were randomly divided into three subgroups of (n = 10) to be polished with Diapol-twist (DT), a Keramik-Politur 4313B Komet polishing kit (KK), and a Horico diamond polisher (HDP). The polished surface roughness and color were recorded. The data were statistically analyzed using a two-way analysis of variance at p < 0.05. The debonded porcelain surfaces across the groups displayed significantly higher mean surface roughness (Ra) compared to glazed surfaces. The debonded 5YZP showed the least Ra at 0.661 (0.09), while the highest Ra was recorded by PICN at 4.057 (0.82). All of the polishing systems evaluated in the study significantly reduced the surface roughness. However, they were unsuccessful in regaining the surface topography of the glazed surface. The flexible discs (DT) produced the smoothest surface, followed by the diamond-impregnated rubber points (KK). Unpolished porcelain surfaces had a discernable mean color difference from glazed surfaces. Polished surfaces from the different polishing systems among the all-ceramic groups achieved a clinically acceptable mean color difference. Polishing debonded rough porcelain surfaces is imperative, and flexible discs performed better in all of the tested CAD–CAM ceramic materials.