Comparison of Surface Roughness of Beech Wood after Sanding with an Eccentric and Belt Sander

Abstract

The presented paper deals with a mutual comparison of the roughness of the sanded radial surface after an eccentric and a belt sander. The beech wood (Fagus sylvatica L.) was sanded with an eccentric sander ETS 125 REQ-PLUS and a belt sander BS-75 E-set from Festool with the grit sizes P40, P60, P80, P100, P120 and P150. The evaluation of the roughness parameters Ra, Rp, Rv, Rz, and Rt was carried out using a digital microscope with a 2.5 mm L-filter and an 8 μm S-filter under the conditions of the technical standard STN EN ISO 21920. The measured results were supported using microscopic analysis of the surface topography especially for surfaces with very high roughness. The experiment shows a lower surface roughness of beech wood sanded with an eccentric sander. The sander created a surface with smaller grooves, removed more protruding fibers and created a more homogeneous surface suitable for subsequent surface treatment.