An Analysis of the Vibration Transmission Properties of Assemblies Using Honeycomb Paperboard and Expanded Polyethylene

Abstract

In the process of logistics, shock and vibration are the most important factors contributing to product damage. Assembling honeycomb paperboard and EPE is commonly used to provide cushioning and anti-vibration effects to materials. Therefore, it is necessary to study the vibration transmission properties of this kind of assembly in the anti-vibration process. The aim of this paper was to experimentally determine the vibration transmission properties of assemblies with honeycomb paperboard and expanded polyethylene (EPE). Through a sinusoidal sweep vibration test of this assembly, the vibration transmission characteristic curves of assemblies with honeycomb paperboard and EPE of different thicknesses were obtained and compared. Assuming the assembly and mass block as a single degree of freedom with a small damping linear system, the damping energy dissipation of the assembly and the resonance frequency were obtained. The vibration transmission property curves of the assembly can be divided into four regions. With an excitation acceleration of 0.5 g and a honeycomb paperboard with a thickness of 60 mm (F60), the vibration transmission rate and the resonance frequency—of the material dampened with EPE at a thickness of 60 mm (E60), and the assembly (F30/E30) with a 30 mm thick honeycomb paperboard and 30 mm thick EPE—increased by −2.5% and −17.5%, −86.9% and 79.3%, and −95.9% and −85.7%, respectively. Compared to the assembly with 20 mm thick honeycomb and 20 mm thick EPE (F20/E20), the vibration transmission rate, the resonance frequency, and the material damping and damping energy dissipation of F40/E20, F30/E30, and F20/E40 increased by 75.6%, 48.3%, and 66.1%; 1.2%, −21.5%, and −38.9%; 241.5%, 82.8%, and 13.3%; and 12.5%, 98.9%, and 106.8%, respectively. Compared to F60 and E60, the damping energy dissipation of F30/E30 increased by 2816.7% and 133.3%, respectively. The assembly of F30/E30 has the smallest vibration transmission rate and the most vibration energy dissipation among these assemblies. This means that the assembly of F30/E30 absorbs the most external vibration energy, while the acceleration that is transmitted to the internal product is minimal. Therefore, in the design of cushioning packaging, according to the characteristics and natural frequency of the internal products, an appropriate assembly can be selected, which should have a lower vibration transmission rate and more vibration energy dissipation, and should not resonate with the internal product. This will provide a theoretical basis for the design of cushioning packaging.