Influence of Preheating on the Microstructure Evolution of Laser Re-Melting Thermal Barrier Coatings/Ni-Based Single Crystal Superalloy Multilayer System

Abstract

Laser surface re-melting (LSR) is a well-known method to improve the properties of atmospheric plasma-spraying thermal barrier coatings (APS TBCs) by eliminating the voids, incompletely melted particles and layered-structure. Laser energy density should be carefully selected to reduce the exposed thermal damage of the underlying single crystal (SX) matrix. Therefore, the purpose of this paper was to identify the effect of introducing induction heating to laser modifying of APS TBCs coated on Ni-based SX superalloy. The results indicated that the preheating of the substrate can lower the laser energy threshold that is required for continuously re-melting the coating. It proved that, in LSR processing of a APS TBCs/ SX matrix multilayer system, the combined method of adopting the low laser energy and preheating at elevated temperature is an effective means of minimizing the cracking susceptibility of top ceramic coating, resulting from decreasing the mismatch strain between the re-melted layer and residual APS TBCs, which can significantly improve the segmented crack condition in terms of crack dimension and crack density. Moreover, this combined method can remarkably lower heat input into an SX matrix and correspondingly the interface stored energy induced by pulsed laser thermal shock, which can effectively lower the tendency for surface recrystallization after the subsequent heat treatment.